Yellow and Red C88/C80 Raised Reflective Road Markers / Reflectors

yellow and red raised reflective pavement markersOur Yellow and Red Model C88/C80 markers from Stimsonite combine the durability of an injection-molded shell with a sturdy inert fill material and advanced optics to ensure high reflectivity. The Yellow/Red C88/C80 Raised Pavement / Road Markers on this page are “two way” and are reflective from both directions. They are used to show yellow to cars going the correct way on a one way street and red to cars going the wrong way. The markers measure 4″ x 4″ and are slightly less than 3/4″ tall. In high intensity traffic conditions, abrasion resistance is crucial to extending the service life of the marker. Our C88/C80 markers include a long-life abrasion resistant coating to enhance the retained reflectivity of the marker. This provides the safest delineation to drivers in critical wet-night conditions

The markers can be applied to asphalt or cement road surfaces using our Melt Down Thermoplastic Pads.  You can also purchase epoxy locally and apply them.  For wooden surfaces like railroad ties you can drill through the middle of the marker and screw them down.  For large application areas you can also use hot tar.

We sell the Yellow and Red  C88/C80 Markers in 2 configurations.  Marker only,  and marker with melt down thermoplastic pad. (See picture at bottom of page)

Our melt down 5 x 5 thermoplastic pads are more permanent.  To install just heat the surface, lay down the pad, continue heating until the pad is melted and then lightly press the marker into the center of the thermoplastic and let cool.

The markers can be applied to asphalt or cement road surfaces using our Melt Down Thermoplastic Pads. You can also purchase epoxy locally and apply them. For wooden surfaces like railroad ties you can drill through the middle of the marker and screw them down. For large application areas you can also use hot tar.

We sell the Yellow and Red C88/C80 Markers in 2 configurations. Marker only and Marker with melt down thermoplastic pad. (See picture at bottom of page)

Our melt down 5 x 5 thermoplastic pads are more permanent. To install just heat the surface, lay down the pad, continue heating until the pad is melted and then lightly press the marker into the center of the thermoplastic and let cool.